[. . . ] 001) immediately after Use it then store it well out of children's reach. Use and before proceeding with any cleaning The packing materials (plastic bags, cardboard or servicing operation. If needed, repairs must only be carried out by This appliance has been designed to operate with specialists using genuine spare parts supplied by alternate current alone. The mains voltage rating corresponds to the value It can be very dangerous to repair the on the data plate. [. . . ] "A3") - Control ("A"): in "AUTOMATIC" position ( ). - Switch: in position 1 = Appliance on (indicator light on) When the two switches are in these positions, the appliance will automatically operate when the electric power tool is turned on. (figures "A4" - "A5" - "A6") - Plug the electric power tool into the socket on the motor unit and then plug the appliance into the electricity main (fig. ATTENTION: The power socket can be used to connect electric power tools with a maximum power rating of 2000 W (fig. 110V~ 60Hz version = The power socket can be used to connect electric power tools with a maximum power rating of 700 W (fig. NEVER plug more than one electric power tool into the socket on the motor unit. - Always keep a spare pack of dust bags pack code 83134B0K ready to hand. Fit the plastic adapter disc (a) on to the filter element (b) and clamp the two parts together by turning the knob in a clockwise direction (fig. It can be used together with the paper bag which, besides preventing the filter cartridge from clogging, also transfers the vacuumed dirt in a rapid and hygienic way. "B5") - To clean up liquid substances, release the motor unit from the drum (fig. - Apply the sponge-filter to the motor support as indicated in the figure alongside. - Place the motor unit back into the drum, making sure that the hinges fit into their slot. - This pre-filter is particularly suitable when fine dust such as cement, talcum and so forth, must be filtered. "B7") These electrostatic post-filters ensure that the air blown back into the room is free from impurities. For good performance of the appliance, both bags must always be kept clean. It is recommended to replace the cartridge after around 100 hours of use. When the vacuumed liquids reach the maximum tolerated level in the drum, the suction action is automatically blocked by the safety float. the user will be warned by the increase in the rpm rate of the motor. If this happens, immediately turn off the appliance and empty the drum. To ensure a partial air flow, do not fully immerse the crevice tool when large amounts of liquid are sucked up from containers. [. . . ] Periodically replace the electrostatic post-filters by levering them up with a coin to release the two slotted covers. Make sure that they fit correctly back in place when they are re-positioned. Check to see how much waste has been vacuumed up, particularly if the appliance is used for bulky materials. After the appliance has been used as a wet cleaner, empty the drum and dry it and the accessories to prevent scaling. [. . . ]